Koncentriškumo aptikimas

Mar 01, 2022 Palik žinutę

Purkštuko išėjimo angos ir lazerio spindulio koaksialumas yra vienas iš svarbių veiksnių, turinčių įtakos pjovimo kokybei. Jei antgalis ir lazeris nėra koaksialūs, tai turės įtakos pjovimo paviršiaus nenuoseklumui. Sunkiais atvejais lazeris gali įkaisti ir sudeginti antgalį.


Paruošimas


image


Pritemdymo žingsniai

  1. Jei operacinėje programinėje įrangoje lazerio galvutės fokusas nenustatytas į 0, pakeiskite lazerio serijos galią į 100 procentų

image

2. Replacement of 1.5mm diameter nozzle

image

3. Attach to the nozzle plane with scotch tape

image

4. Click the laser shot button and release it immediately

image

5. Remove the tape and check the imprint, be careful not to turn the direction, there is a circle with the size of the aperture on the imprint, observe if the light spot is in the exact center of the nozzle circle

image

6. If the light spot is not in the center of the nozzle circle, you need to adjust the position of the light spot by rotating the left and right screws with the Allen wrench until the light spot moves to the center of the circle

image

7. Adjust it according to the corresponding position of the light spot and the circle

image

8. After repeated testing and adjustment, the coaxiality adjustment operation is completed until the light spot moves to the center of the circle.